  Windows NT 4.0

  Introduction:
  -------------
  This document describes the procedure to install Windows NT v4.0 driver
  for TRENDnet, TEG-PCITXR  32-bit 10/100/1000Mbps PCI ADAPTER.

  Location of NT 4.0 Driver : WindowsDrv\WINNT40\RTLNIC4.SYS

  Installing driver procedure on Microsoft Windows NT:
  ----------------------------------------------------
  When you are in Windows NT :
  1. In the Main group of NT, select the "Control Panel" icon.

  2. In the Control Panel window, choose the "Network" icon.

  3. In the Network Settings dialog box, choose the "Add..." 
     button in the "Adapters" page. The Select Network Adapter 
     dialog box appears.

  4. Press the "Have Disk..." button to install driver.

  5. Insert the TEG-PCITXR driver CD-ROM, enter drive and pathname
     (ex. D:\WindowsDrv\WINNT40) which is the path where the setup 
     file OEMSETUP.INF is located, and then choose the "OK" button.

  6. The screen will appear "Select OEM Option" dialog, and choose the
     "OK" button.

  7. The screen will appear "Speed/Duplex Mode" dialog box which is
     provide by RTLNIC4.SYS driver. The default value is "Auto" so that
     the TRENDnet, TEG-PCITXR  32-bit 10/100/1000Mbps PCI ADAPTER and its 
     driver RTLNIC4.SYS will auto-detect the speed/duplex, while the 
     RTLNIC4.SYS is loading.
     
     The other values, "10 Half Duplex", "10 Full Duplex", "100 Half Duplex",
     "100 Full Duplex" or "1000 Full Duplex", are only used when you want to
     forced TRENDnet, TEG-PCITXR  32-bit 10/100/1000Mbps PCI ADAPTER to 10Mb 
     Half, 10Mb Full, 100Mb Half, 100Mb Full or 1000Mb Full.

  8. The screen will appear "Input Network Address" dialog box which is
     provide by RTLNIC4.SYS driver. This option is only required when you have
     more than one TRENDnet, TEG-PCITXR  32-bit 10/100/1000Mbps PCI ADAPTER on 
     this computer. Select "Skip" if only one adapter is installed on this 
     computer.

  9. The "Input Tx Early Threshold" display in next screen. Press "OK" button
     to continue installation.

  10. You can choose the "Properties..." button to modify all parameter above.

  11. Press the "Close" button, the NT will then perform the binding process.
      If any additional network software options were installed, you may be
      prompted for specific information for these packages.

  12. Restarting your system you will acquire network service.

