  Windows 98 SE

  Introduction:
  -------------
  This document describes the procedure to install Windows 98 SE driver
  for TRENDnet, TEG-PCITXR  32-bit 10/100/1000Mbps PCI ADAPTER.

  Location of Windows 98 SE Driver : WindowsDrv\WIN98SE\RTNIC.SYS

  Installing driver for Windows 98 SE:
  ------------------------------------
  Before you start with the installation process, make sure that your
  adapter should be properly installed in your PCI bus slot.
  Executing Windows98 SE, it will auto-detect your system configuration and
  find the adapter hardware.
  (If Windows98 SE does not prompt that it detects the PCI Ethernet Controller,
  there must be something wrong with the TEG-PCITXR Family Gigabit Ethernet
  adapter or your system enviroment.)

  1. Ask you to select which driver you want to install, select "Search for
     the best driver for your device.(Recommended)".

  2. Insert the TEG-PCITXR Windows driver CD-ROM and specify
     the setup file pathname(ex. D:\WindowsDrv\WIN98SE\).

  3. Windows98 SE will appear some messages to insert Windows98 SE system disk
     to complete setup step.

  4. Windows98 SE will finish the other installation procedure automatically,
     then Windows98 SE will ask you to restart your system.

